Montreal, Canada
June 16, 2002
June 16, 2002
June 19, 2002
2153-5965
5
7.652.1 - 7.652.5
10.18260/1-2--10263
https://peer.asee.org/10263
397
Main Menu
Session 3568
Incorporating Design in an Introduction to Dynamics Course Wendy Reffeor, Ph.D. Seymour and Esther Padnos School of Engineering Grand Valley State University Grand Rapids, MI 49504
Abstract
Prompted by EC2000, a contest to design a spring-powered catapult was incorporated into the Dynamics course at Grand Valley State University. The catapult was required to launch a projectile to clear an obstacle and strike a target while not exceeding a specified ceiling. Students brain stormed design concepts, completed their design calculations, including analysis of the rigid body motion of the catapult and the motion of the projectile, and created component and assembly drawings prior to constructing their catapults. They then constructed prototypes of their designs, tested them, revised them as needed with complete documentation of changes and competed in the contest.
Evaluation of the project was based upon the accuracy of the analysis of the mechanism, the consistency between the calculations and the completed mechanism, the engineering drawings of the mechanism and the conclusions drawn from the experience.
This project gave students the opportunity to apply the concepts learned in a normally purely theoretical course to the design and implementation of a real, open-ended, design problem. In addition, it emphasized good design practices by encouraging students to design their catapult completely prior to building it, build, test, and modify the prototype and prove they met the design requirements.
Students learned that design is an iterative process, that successful design requires careful planning and that there are many ways to solve any problem. In addition, this project offered the students a junior level, guided design experience.
Introduction
Design and build projects are incorporated in many of Grand Valley State University’s (GVSU) courses to present a more applied approach to engineering, while maintaining the rigor expected of engineering curricula. From these projects, students learn design procedures, reinforce their learning of design tools such as mathematical modeling programs, mechanical drawing programs and physical modeling programs, learn the value of carefully planning projects, and learn that design is an iterative process even when calculations are carefully performed.
Main Menu
Reffeor, W. (2002, June), Incorporating Design In An Introduction To Dynamics Course Paper presented at 2002 Annual Conference, Montreal, Canada. 10.18260/1-2--10263
ASEE holds the copyright on this document. It may be read by the public free of charge. Authors may archive their work on personal websites or in institutional repositories with the following citation: © 2002 American Society for Engineering Education. Other scholars may excerpt or quote from these materials with the same citation. When excerpting or quoting from Conference Proceedings, authors should, in addition to noting the ASEE copyright, list all the original authors and their institutions and name the host city of the conference. - Last updated April 1, 2015