Conference Session

Engineering Management Division Technical Session 2

Collection

2014 ASEE Annual Conference & Exposition

Authors

Sangarappillai Sivaloganathan, United Arab Emirates University; Ali H. Al-Marzouqi, United Arab Emirates University

Tagged Divisions

Engineering Management

through a standard door is arequirement that has become a limiting factor for some designs. Design forManufacturing is a philosophy and mind set aimed at designing parts and productsthat can be produced more easily and it is applied heavily at this stage.5.5 Detail DesignAt this stage the entire details including material and dimensions of parts are definedcompletely so that the product can be manufactured. Often a CAE software is used tomodel the parts and assembly at this stage. This contains all the details needed for anyanalysis. Engineering calculations would have been carried out earlier at part and sub-assembly levels but now the complete product is available for analysis. Normally allpossible analyses are not carried out. The worst-case