Conference Session

Practical Teaching

Collection

2013 ASEE Annual Conference & Exposition

Authors

Rex C Kanu, Ball State University

Tagged Divisions

Manufacturing

Page 23.110.2Process Flow DiagramTo identify the process parameters to examine, students created a process flow diagram andselected process parameters they thought could affect parts mass if process variability occurredin these parameters. Figure 1 shows the process flow diagram for the injection moldingcomponent of the study. The parameters chosen for the study were cooling time, cushion finalposition, plasticizing time, and screw position at change-over. Figure 1. Process Flow Diagram of Plastics Injection MoldingMaterialThe plastics resin used in this work was polycarbonate (PC) and acrylonitrile-butadiene-styrene(ABS) blend manufactured by Bayer. The trade name of the resin is BayBlend® FR 2010. Theresin was dried at 200 °F

Conference Session

Practical Teaching

Collection

2013 ASEE Annual Conference & Exposition

Authors

Lam F. Wong, Cuyahoga Community College, Metropolitan; Henry Griffith, Wright State University

Tagged Divisions

Manufacturing

Page 23.84.13Society, Vol.14, No. 2, Art. 32.[3] The Dow Jones Sustainability Indices, as Benchmarks for Investors who Integrate Sustainability Considerationsinto their Portfolio. http://www.sustainability-indexes.com/[4] DuPont Sustainability Section of Company Website. http://www2.dupont.com/inclusive-innovations/en-us/gss/sustainability.html[5] Czuchry, Andrew; Oarker, Michael; and Bridges, Robert (2010). Achieving Organizational Sustainability: AnEngineering Management Challenge or Opportunity? American Society for Engineering Education, AC 2010-60.[6] Zhang, Qiong; Vanasupa, Linda; Mihelcic, James R.; Zimmerman, Julie Beth; and Platukyte, Simona (2012).Challenges for Integration of Sustainability into Engineering Education, American

Conference Session

Manufacturing Partnerships

Collection

2013 ASEE Annual Conference & Exposition

Authors

Sheng-Jen Hsieh, Texas A&M University

Tagged Divisions

Manufacturing

s tudents bec o m e m o re info rm ed abo ut what ac areer in res earc h invo lves . To what extent was this o bjec tive m et fo r yo u? Res po ns e Res po ns eAns wer Optio ns Perc ent Co untNot met 0.0% 0Partly met 0.0% 0Mostly met 20.0% 1Completely met 80.0% 4 answered questio n 5The third

Conference Session

Practical Teaching

Collection

2013 ASEE Annual Conference & Exposition

Authors

William T. Evans PhD P.E., University of Toledo

Tagged Divisions

Manufacturing

70E,it will enhance any instruction on the topic of electrical safety in the technical electrical courses,especially with regard to the requirements of NFPA 70E.Some key points to be aware of is that the guide does not cover electrical systems below 50 voltsor over 600 volts AC, and is not applicable to any work related to utility systems. The guidecontains basic information regarding "qualified persons" (those legally permitted to do certainkinds of electrical work), basic safety and energy control procedures, arc flash hazards and arcratings, personal protective equipment (PPE) and fire retardant clothing, first aid, and NFPA 70Edefinitions