Conference Session

Innovations in Materials Education

Collection

2012 ASEE Annual Conference & Exposition

Authors

Qu Jin, Purdue University, West Lafayette; Senay Purzer, Purdue University, West Lafayette; P.K. Imbrie, Purdue University, West Lafayette

Tagged Divisions

Materials

AC 2012-3628: MEASURING FIRST-YEAR ENGINEERING STUDENTS’KNOWLEDGE AND INTEREST IN MATERIALS SCIENCE AND ENGI-NEERINGQu Jin, Purdue University, West Lafayette Qu Jin is a graduate student in the School of Engineering Education at Purdue University. She received a M.S. degree in biomedical engineering from Purdue University and a B.S. degree in material science and engineering from Tsinghua University in China. Her research focuses on modeling student success outcomes, which include placement, retention, academic performance, and graduation.Dr. Senay Purzer, Purdue University, West Lafayette Senay Purzer is an Assistant Professor in the School of Engineering Education and is the Director of Assessment Research for the

Conference Session

Novel Approaches to Teaching Materials

Collection

2011 ASEE Annual Conference & Exposition

Authors

Lakshmi Munukutla, Arizona State University, Polytechnic campus

Tagged Divisions

Materials

AC 2011-1815: COURSE EMBEDDED CLASS ROOM ASSESSMENT TECH-NIQUE FOR THE STEM EDUCATIONLakshmi Munukutla, Arizona State University, Polytechnic campus Lakshmi Munukutla received her Ph.D. degree in Solid State Physics from Ohio University, Athens, Ohio and M.Sc and B.Sc degrees from Andhra University, India. She has been active in research and published several journal articles. She is a professor in the Department of Engineering Technology at Arizona State University. Page 22.388.1 c American Society for Engineering Education, 2011 Course Embedded Class Room Assessment

Conference Session

Materials Division Technical Session 2

Collection

2015 ASEE Annual Conference & Exposition

Authors

Kathleen Meehan, University of Glasgow; Robert H. Hadfield, University of Glasgow; Andrew Phillips

Tagged Divisions

Materials

. However, there was a lengthy warm-up time as the drive current to thepower resistor was restricted to a maximum of 0.8 A, the maximum current that the 12V AC-to-DC adaptor used as the power supply for the apparatus could drive through the 15  power resistor.The circuit had to be turned on for approximately 20 minutes before the apparatus was ready foruse by the students. As students would perform the measurements needed to calculate electricalresistance prior to the measurements needed for the calculations of thermal conductivity andspecific heat capacity, the warm-up time was acceptable as long as the apparatus was turned on atthe beginning of the lab session.A power switch was integrated into the circuit along with two LED indicators, a yellow

Conference Session

Creating 'Materials' Awareness

Collection

2007 Annual Conference & Exposition

Authors

Lawrence Genalo, Iowa State University; Scott Chumbley, Iowa State University

Tagged Divisions

Materials

AC 2007-3113: AN UNDERGRADUATE MATERIALS RECRUITMENT ANDOUTREACH PROGRAMLawrence Genalo, Iowa State University LAWRENCE J. GENALO is Professor and Assistant Chair of the Department of Materials Science and Engineering at Iowa State University. He received a Ph. D. in Applied Mathematics with Systems Engineering emphasis in 1977, served as Chair for Freshman Programs and DELOS Divisions, and runs the Toying With TechnologySM Program at Iowa State and the recruitment program in the Materials Science and Engineering Department.Scott Chumbley, Iowa State University L.S. CHUMBLEY Scott Chumbley is a Professor in the Materials Science and Engineering Department at Iowa State University (ISU) and

Conference Session

Clearing up Student Misconceptions in Materials

Collection

2010 Annual Conference & Exposition

Authors

Jacquelyn Kelly, Arizona State University; Keith Heinert, Arizona State University; Jessica Triplett, Arizona State University; Dale Baker, Arizona State University; Stephen Krause, Arizona State University

Tagged Divisions

Materials

AC 2010-1156: UNCOVERING AND REPAIRING ATOMIC BONDINGMISCONCEPTIONS WITH MULTIMODAL ASSESSMENT OF STUDENTUNDERSTANDING IN AN INTRODUCTORY MATERIALS COURSEJacquelyn Kelly, Arizona State University Jacquelyn Kelly, Arizona State University Jacquelyn Kelley has an M.S. in Materials Science and is a Ph.D. student in the College of Education at Arizona State University. Her BS degree is in Physics and Chemistry. Her principle research areas are inquiry-based learning and development and assessment of inquiry-based modules in materials science and engineering. She teaches physics, chemistry and mathematics in a local arts high school.Keith Heinert, Arizona State University Keith Heinert is an

Conference Session

Clearing up Student Misconceptions in Materials

Collection

2010 Annual Conference & Exposition

Authors

Stephen Krause, Arizona State University; Jacquelyn Kelly, Arizona State University; Dale Baker, Arizona State University; Sharon Kurpius-Robinson, Arizona State University

Tagged Divisions

Materials

AC 2010-1157: EFFECT OF PEDAGOGY ON CONCEPTUAL CHANGE INREPAIRING MISCONCEPTIONS OF DIFFERING ORIGINS IN ANINTRODUCTORY MATERIALS COURSEStephen Krause, Arizona State University Stephen Krause is a Professor in the School of Materials in the Fulton School of Engineering arrived at Arizona State University in 1981 after completing his research on polymer deformation at the University of Michigan. Courses he has developed and taught include; Bridging Engineering and Education, Materials Characterization, Polymers and Composites, and Materials Capstone Design,. Innovative learning tools and assessments he has developed include: Materials Mentor Fold Out Notes; Materials Lecture Work Notes

Conference Session

Novel Approaches to Teaching Materials

Collection

2011 ASEE Annual Conference & Exposition

Authors

Jacquelyn E. Kelly, Arizona State University; Stephen J. Krause, Arizona State University; Dale R. Baker, Arizona State University

Tagged Divisions

Materials

AC 2011-1096: PREDICTING CONCEPTUAL GAIN IN AN ATOMIC BOND-ING MODULEJacquelyn E. Kelly, Arizona State University Jacquelyn Kelly is doctoral student in Science Education at Arizona State University. Her Master’s de- gree is in Materials Science and Engineering and her undergraduate degree is in Physics and Chemistry. Her principle research interests are situated in engineering education and include conceptual develop- ment, engineering academic language acquisition, and the role of motivation and emotion on these things. She is also invested and passionate about K-12 education as she teaches physics, chemistry, and science foundations at New School for the Arts and Academics, an alternative arts high school.Stephen

Conference Session

Materials Division Technical Session 1

Collection

2019 ASEE Annual Conference & Exposition

Authors

Cheng-Wei Lee, Univ of Illinois, Urbana-Champaign; Andre Schleife, University of Illinois, Urbana-Champaign; Dallas R. Trinkle , University of Illinois, Urbana-Champaign; Jessica A. Krogstad, University of Illinois, Urbana-Champaign; Robert Maass, University of Illinois, Urbana-Champaign; Pascal Bellon, University of Illinois, Urbana-Champaign; Jian Ku Shang, University of Illinois, Urbana-Champaign; Cecilia Leal, University of Illinois, Urbana-Champaign; Matthew West, University of Illinois, Urbana-Champaign; Timothy Bretl, University of Illinois, Urbana-Champaign; Geoffrey L. Herman, University of Illinois, Urbana-Champaign; Shengchang Tang, University of Illinois, Urbana-Champaign

Tagged Divisions

Materials

Laboratory on a project that aimed at a description of non-adiabatic electron ion dynamics. He received the NSF CAREER award, the ONR YIP award, and the ACS PRF doctoral new investigator award.Prof. Dallas R. Trinkle , University of Illinois, Urbana-Champaign Dallas R. Trinkle is a professor in Materials Science and Engineering at Univ. Illinois, Urbana-Champaign. He received his Ph.D. in Physics from Ohio State University in 2003. Following his time as a National Research Council postdoctoral researcher at the Air Force Research Laboratory, he joined the faculty of the Department of Materials Science and Engineering at Univ. Illinois, Urbana-Champaign in 2006. He was a TMS Young Leader International Scholar in 2008