Conference Session

Technical Sessions 2

Collection

2024 Fall ASEE Mid-Atlantic Section Conference

Authors

Margaret A Hunter, Hofstra University; Lynn A. Albers, Hofstra University; Jessica Santangelo, Hofstra University; Jacqueline Lee, Nassau Community College; Catherine Weinstein, Nassau Community College; Scott T Lefurgy, Hofstra University; Sean A Roberts, Nassau Community College; Suzanne Trabucco, Nassau Community College; Kristin Weingartner, Hofstra University

Tagged Topics

Diversity, Professional Papers

Reasons for being Topics/Skills in Notes differences? different? Common Part 2: Assessment and Pedagogy Our goal is to answer the following questions: (1) To what extent are students in our introductory [discipline] courses exposed to similar assessment types and classroom or laboratory experiences? (2) To what extent are there differences between the introductory [discipline] assessment types and classroom or laboratory experiences at NCC and HU? Why do those differences exist? Table 2: Example table to put on a big sticky to map differences and similarities between assessment types and classroom or

Conference Session

Technical Sessions 4

Collection

2024 Fall ASEE Mid-Atlantic Section Conference

Authors

Raymond K.F. Lam, The City University of New York, Queensborough Community College; Uzair Ali Abbas, City University of New York, Queensborough Community College; Bernard Hunter; Joseph A Seiter, City University of New York, Queensborough Community College

Tagged Topics

Diversity, Professional Papers

. Bernard Hunter >> Bernard Hunter is the general lab manager of QCC 3D Printing Laboratories, responsible for additive manufacturing machines such as the Stratsys J750, Fortus 450 , Object 30 and UPRINT Dimitrios Stroumbakis dstechcomm@verizon.netMr. Joseph A Seiter, City University of New York, Queensborough Community College Received my Degree in Mechanical Engineering Technology (AAS) From Queensborough Community College. Graduated in 1976. Worked as a Customer Service Engineer at IBM for 33 years. Also worked part time as a College Laboratory technician for the Engineering Technology Department at QCC since 1992. Hired full time as a CLT for the same department in 2017. ©American

Conference Session

Technical Sessions 4

Collection

2024 Fall ASEE Mid-Atlantic Section Conference

Authors

Marco Hermida, State University of New York at New Paltz; Ping-Chuan Wang, State University of New York at New Paltz; Nancy Campos, SUNY New Paltz; Aileen Pastrana, State University of New York at New Paltz; Bianca Bermudez, State University of New York at New Paltz; Shaima Herzallah, State University of New York at New Paltz; Christopher Monvil, State University of New York at New Paltz; Tenmetey Tetteh-Nartey, State University of New York at New Paltz

Tagged Topics

Diversity, Professional Papers

slope, reflecting lowest variation. This isconsistent with the smaller error bars seen in Figure 9, suggesting that the 0° print orientationproduces more predictable and consistent failure results. In contrast, the shallow slopes observedfor the 45° and 90° print orientations indicate greater variability in the failure loads for theseorientations, making them less predictable under applied tensile load.Based on this log-normal statistical analysis, it is crucial to note the important implication inlarge-scale manufacturing using 3D-printing. Although the sample size in a laboratory settingcan be very limited, typically about 20 in our case, the strength at very low percentile (such as inthe parts-per-million, or ppm, level) can be projected