Paper ID #24040Effective Stress and Upward Seepage Laboratory DemonstrationMr. Matthew William Wooden, Purdue University Northwest Matthew Wooden is an undergraduate student at Purdue University Northwest pursuing his Bachelor’s degree in Civil Engineering with a minor in applied mathematics. He has strong interests in geotechnical engineering, more specifically, soil mechanics and foundation engineering, as well as hydrology and hydraulics.Prof. Jiliang Li P.E., Purdue University Northwest Dr. Jiliang Li, D.Eng, Ph.D., P.E., M.ASCE, M.ASEE, is an Assistant Professor of Civil Engineering at Purdue University
Paper ID #23668Using 3-D Printing in a Laboratory Setting to Teach Design PrinciplesDr. Suzette R Burckhard, South Dakota State University Dr. Burckhard earned a BS in Engineering Physics, a BS in Civil Engineering, (both from South Dakota State University) an MS in Physics. an MS in Chemical Engineering, and a PhD in Civil Engineering with emphasis in Environmental Engineering, from Kansas State University. She has been on staff at South Dakota State University since 1997 in the Civil and Environmental Engineering department where she is a professor and assistant department head. Dr. Burckhard is a member of ASCE, ASEE
Paper ID #21714Assessing the Influence of Lecture/Laboratory Instructor Pairings on StudentPerception and Learning OutcomesDr. Simon Thomas Ghanat P.E., The Citadel Dr. Simon Ghanat is an Assistant Professor of Civil and Environmental Engineering at The Citadel (Charleston, S.C.). He received his Ph.D., M.S., and B.S. degrees in Civil and Environmental Engineering from Arizona State University. His research interests are in Engineering Education and Geotechnical Earthquake Engineering. He previously taught at Bucknell University and Arizona State University.Dr. J. Michael Grayson, The Citadel Dr. J. Michael Grayson is a
current research interests mainly focus on Smart Structures Technology, Structural Control and Health Monitoring and Innovative Engineering Education.Mr. Alec William Maxwell, San Francisco State University Alec Maxwell is currently an graduate student in the School of Engineering at San Francisco State Uni- versity (SFSU). Besides actively conducting research on innovative tools for engineering education in the Intelligent Structural Hazards Mitigation Laboratory at SFSU with Prof. Zhaoshuo Jiang, he also serves the community as the President of the American Society of Civil Engineers for the SFSU chapter.Prof. Zahira H Merchant, San Francisco State UniversityDr. Philip Scott Harvey Jr., University of Oklahoma Scott
. However, Allendoerfer et al. [15] foundthat student perceptions of faculty support are significantly influenced by class size andinstitution type. Astin [16] noted that institution type does not have a strong influence on theeffectiveness of undergraduate education, but that the environment created by faculty andstudents plays a stronger role.The purpose of this study is to examine several educational factors (i.e., institution type, classsize, class meeting time, class length and format, laboratory format, and faculty attributes) thatmay correlate with the amount of knowledge gained in the conceptual understanding ofgeotechnical engineering topics. The study was carried out at six institutions with civilengineering programs: The Citadel
of the groups did the project in asphalt and asphalt concrete, because theinstructor’s research laboratory has the resources to allow testing of these students. All the testingtime for the students was outside the class time. To ensure that the students get the most of out oftheir hands-on experience, the experimental protocol was vetted thoroughly. The civil engineeringtechnician also assisted the students in testing. For each of the materials, the objectives was thefollowing:1) Determine whether the material is linear viscoelastic?2) Determine if time-temperature superposition is applicable?3) Develop a rheological model, and4) Explain impact of the above results in practical applications.The scope and depth of testing was discussed with
Recommendations The following list provides recommendations for successful future implementation of the proposed SHRP2 vertical integration approach. These recommendations are based on feedback from the SHRP2 module instructors. ̶ Incorporate more SHRP2 hands-on or field components. ̶ Develop more group and individual class projects that focus on utilizing SHRP2 products. ̶ Develop instructions to explain selected SHRP2 products in detail in class or laboratory settings. ̶ Modify existing survey questions for the next iteration to evaluate method of instructions and instructor. ̶ Develop an “instruction manual
,Engineering Disasters, and Technology, Society, and Values). The Civil Engineering departmentat Oregon Tech has a strong laboratory component in its curriculum with a majority ofprogrammatic courses including a laboratory. Given the motivations of these two departmentsand mutual interest of the project faculty in bridges, and Conde B. McCullough (Figure 1) inparticular, the faculty identified the potential for a field course to tour important Oregon bridges.Emphasizing those constructed to complete the Oregon coast highway, the course brings thehistory of these bridges together with their design and construction details. Changes in bridgedesign practice were discussed as an analog to the development of civil engineering moregenerally. Figure
focus on Smart Structures Technology, Structural Control and Health Monitoring and Innovative Engineering Education.Mr. Alec William Maxwell, San Francisco State University Alec Maxwell is currently an graduate student in the School of Engineering at San Francisco State Uni- versity (SFSU). Besides actively conducting research on innovative tools for engineering education in the Intelligent Structural Hazards Mitigation Laboratory at SFSU with Prof. Zhaoshuo Jiang, he also serves the community as the President of the American Society of Civil Engineers for the SFSU chapter.Prof. Zahira H Merchant, San Francisco State University c American Society for Engineering Education, 2018 Using Mobile
University in 1987 and a Ph.D. degree in Civil Engineering from the University of Colorado at Boulder in 1997.Dr. Pamalee A. Brady, California Polytechnic State University, San Luis Obispo Pamalee Brady is a Professor at California Polytechnic State University, San Luis Obispo. She teaches courses in structural systems, concrete, steel and wood design as well as structural engineering courses for architecture and construction management students. Prior to joining the faculty at Cal Poly she worked in applied research at the U.S. Army Construction Engineering Research Laboratory in Champaign, Illinois. She is a member of the Education Committee of the ASCE Forensic Engineering Division and an Asso- ciate Editor of the ASCE
graduated with a B.S in Chemical Engineering from the University of Arizona.Dr. Anthony J. Marchese, Colorado State University Anthony J. Marchese is the Associate Dean for Academic and Student Affairs, Director of the Engines and Energy Conversion Laboratory and Professor of Mechanical Engineering in the Walter Scott, Jr. College of Engineering at Colorado State University. Marchese holds a Ph.D. and M.A. in Mechanical and Aerospace Engineering from Princeton University and B.S. and M.S. degrees from Rensselaer Poly- technic Institute. His research areas include internal combustion engines, alternative fuels, combustion, chemical kinetics, microgravity experiments, methane emissions and biomass cookstoves. He is
meets twice a week for75 minutes and is taught in two sections with approximately 30 students in each section. AtDrexel, the four-credit class meets twice a week for 80 minutes and once a week for two hours(including a laboratory portion) as one large section. The class size at Drexel typically rangesfrom 60 to 80 students, but the last offering (fall 2017) had an abnormally low enrollment of 34students. Although the academic calendar at Drexel is on a quarter system and Villanova issemesters, the number of class meetings is essentially the same for both schools. For bothuniversities, the geology course fulfills a science requirement for ABET.In the past, engaging and interesting engineering students in geology at both universities hadbeen a
graduations: 1. Transform Teaching and Learning: Improved retention as a result of expanding our undergraduate teaching assistance (UTA) programs and institutionalizing a formal UTA training pedagogy. A working knowledge in best practices will enable UTAs to be both effective and engaging in the laboratory and/or classroom. 2. Increase Faculty and Student Interactions: Improved retention as a result of implementing university-wide and discipline-specific (intentional) community building activities that foster STEM students’ sense of identification with STEM departments.PRIMES conceptual framework was designed around three groups that intersect: STEM faculty,STEM undergraduates, and STEM Undergraduate Teaching
individuals who have spent countless hours developing theGeoGebra software package and its related manuals, videos, and other help sources. Withoutyour efforts, I would have no hope of compiling the JavaScript code used for my interactives. Ialso wish to thank my students for their willingness to engage in all of my experimental learningmethods in the hope I can find something that they will benefit from.References[1] M. Prince, "Does active learning work? A review of the research," Journal of engineering education, vol. 93, pp. 223-231, 2004.[2] T. de Jong, M. C. Linn, and Z. C. Zacharia, "Physical and Virtual Laboratories in Science and Engineering Education," Science, vol. 340, pp. 305-308, 2013.[3] E. Wheeler and R. L
University; at Texas A&M since 2006. Prior employment experience includes: Oceanographer for US Naval Research Laboratory (1995-2006), Post- Doctoral Fellow at US Naval Research Laboratory (1994-1995), Hydraulic Engineer at US Waterways Experiment Station, US Army Corps of Engineers (1987-1989). Ph.D. from University of Delaware (1994), M.S. from University of California, Berkeley (1987), B.S. from California State Polytechnic University (1986), all in Civil Engineering. Research interests include theory and modeling of ocean wave dynamics, beach erosion, coastal engineering, nearshore circulation, and ocean wave generation by wind.Miss Veronica S. Rodriguez Chavarria Veronica S. Rodriguez Chavarria is a graduate
. Teamwork ✓ ✓ ✓15. Professional Growth and ✓ ✓ ✓ responsibility16. Ethics ✓ ✓ ✓ ✓ Table 2b. Cognitive Technologist Specialty Outcomes for CET-BOK Level 1 Level 2 Level 3 Level 4 Level 5 Level 6 Outcome Know Comprehend Apply Analyze Synthesize Evaluatea. Survey and Geomatics ✓ ✓ ✓b. Field and Laboratory Data ✓ ✓ ✓ Collectionc. Data Processing ✓ ✓ ✓d. Drafting Software ✓ ✓ ✓e. Testing Standards
Steel Construction, Chicago, IL.[9] Civjan, S. (2010) "Core Teaching Aids for Structural Steel Design Courses" American Institute of Steel Construction. Retrieved from https://www.aisc.org/education/university- programs/ta-core-teaching-aids-for-structural-steel-design-courses/[10] Hale, M., Freyne, S., Durham, S. (2007) “Student Feedback And Lessons Learned From Adding Laboratory Experiences To The Reinforced Concrete Design Course” Proc. ASEE Annual Conf. & Expo., Honolulu.[11] Behrouzi, A. (2016) “Physical Artifacts in Introductory-level Reinforced Concrete Design Instruction” Proc. ASEE Annual Conf. & Expo., New Orleans.[12] Robinson, I. (2002) “Survey of Education and License Requirements for Structural
Arkansas, Fayetteville. Before joining the U of A faculty in 1996, he served in the US Army as an engineer officer for 24 years. During his military career Dennis had the unique opportunity to build roads, airfields and other facilities on five different continents and spend over 11 years as a member of the faculty at the US Military Academy. His current research interests include laboratory and field determination of geotechnical material properties for transportation systems and the use of remote sensing techniques to categorize geohazards. He has published over 85 peer reviewed articles relating to his research and educational activities. Dennis holds BS and MS degrees in Civil Engineering from the University of
Military Academy. His current research interests include laboratory and field determination of geotechnical material properties for transportation systems and the use of remote sensing techniques to categorize geohazards. He has published over 85 peer reviewed articles relating to his research and educational activities. Dennis holds BS and MS degrees in Civil Engineering from the University of Missouri-Rolla (now Missouri University of Science and Technology), an MBA from Boston University and a Ph.D. from the University of Texas-Austin. He is a registered professional engineer in Arkansas and Colorado.Dr. Decker B. Hains, Western Michigan University Dr. Decker B. Hains is a Master Faculty Specialist in the Department
State University Dr. David Hurwitz is an Associate Professor of Transportation Engineering in the School of Civil and Construction Engineering at Oregon State University and is the Director of the OSU Driving and Bicycling Simulator Laboratory. Dr. Hurwitz conducts research in transportation engineering, in the areas of traffic operations and safety, and in engineering education, in the areas of conceptual assessment and curriculum adoption.Mr. Masoud Ghodrat Abadi, Oregon State University Masoud Ghodrat Abadi is a PhD candidate and a graduate research assistant in school of Civil and Con- struction Engineering at Oregon State University. He received his MSc degree in Transportation Engi- neering from Sharif
. (2005). A Method to Demonstrate the Importance of Homework, Innovations in Engineering Education, Mechanical Engineering Department Heads, v. 2005Phelps, A., Sliger, L., Degracia, S., and Ganzerli, S. (2008). “Integration of New Teaching Methodologies into a Laboratory Based Course.” 18th Analysis and Computation Specialty Conference, 1-11.Prince, M. Does active learning work? A review of the research. J. Eng. Educ. 93, 3, 223–231 (2004).Rafiq, Y. (2010). “A Radical Rethink in Educating Engineering Students”, 19th Analysis & Computation Specialty Conference, 366-376.Savin-Baden, M. (2003). Facilitating Problem
, construction, and laboratory testing experience was implemented for students to gain adeeper knowledge related to the bending and shear capacity of reinforced concrete beams. Thisexperience was part of the course homework grade. A design project was completed over thecourse of the semester, which contributed to 10% of the final grade. The grading style at University B focused on the problem solving process rather than thenumerical result. A scoring rubric was made for each problem prior to grading each examquestion. Partial credit was given for providing the correct thought process and writing down thecorrect steps in solving the problem. Deductions made for mistakes were not carried through theproblem. Points were taken off for math errors or