UY. Test Case 5 harmonic response plots are incorrect. Q OK, but natural frequencies OK, except the user has to specify OK listed in rad/s instead of Hz. the freq. range in rad/s, while Also, there is a node instructions specify Hz. Phase numbering problem in the angles are reported in radians, printed mode shapes. instead of degrees, as specified in the instructions, and sign is wrong on the phase angles
softwareare found in virtually every area of scienceand engineering.Program:1–2:30 pm Intro and Live Demo2:30–4 pm Hands-on Session If you have any questions do not hesitateto contact Nicholas Snaith by email atnicholas@comsol.com or phone at(781) 273-3322.LabVIEWHands-on Campus Workshop byNational InstrumentsIn this workshop you will get:1. ntroduction to DAQ hardware— I capabilities, driver software, where to go for help2. ntroduction to LabVIEW—User Interfaces, I Block Diagram, Collecting Data, Signal Processing, Writing to Disk. Learn how to create complete LabVIEW applications from scratch in minutes with interactive Express VIs and I/O assistants3. &A —Address specific applications you Q have in mindRegistered
softwareare found in virtually every area of scienceand engineering.Program:1–2:30 pm Intro and Live Demo2:30–4 pm Hands-on Session If you have any questions do not hesitateto contact Nicholas Snaith by email atnicholas@comsol.com or phone at(781) 273-3322.LabVIEWHands-on Campus Workshop byNational InstrumentsIn this workshop you will get:1. Introduction to DAQ hardware— capabilities, driver software, where to go for help2. Introduction to LabVIEW—User Interfaces, Block Diagram, Collecting Data, Signal Processing, Writing to Disk. Learn how to create complete LabVIEW applications from scratch in minutes with interactive Express VIs and I/O assistants3. Q&A —Address specific applications you have in mindRegistered